Advanced Settings - Sony CLIE GEAR Mode D'emploi

Advanced Settings

Setting a network manually
When it is necessary to set a network IP address or DNS address,
follow the procedure below.
1
Tap [Advanced Setup] in the bottom right-hand corner
of the [Wireless LAN Setup] input screen.
2
Tap the [Auto] check box in [IP Address] or [DNS
Address]. The check mark disappears.
The IP Address input screen or the DNS Address input screen appears.
3
Enter necessary addresses.
4
Tap [OK] when you complete the setting.
Disabling the power saving mode
1 Tap [Advanced Setup] in the bottom right-hand corner of the
[Wireless LAN Setup] input screen.
2 Tap the [Enable] check box in [PowerSaveMode]. The check
mark disappears.
The power saving mode is disabled.
Tip
When the communication conditions are not good, you can disable the
power saving mode to maximize the battery power and achieve better
communications. However, it will make the battery life shorter.
Normally, the power saving mode is recommended.
US
20