User Manual Of Brushless Speed Controller - FMS 1100mm P-51 V2 Dago Red Manuel D'utilisation

E
N

User Manual of Brushless Speed Controller

Thanks for purchasing our Electronic Speed Controller (ESC). High power system for RC model is very dangerous,
please read this manual carefully. In that we have no control over the correct use, installation, application, or
maintenance of our products,no liability shall be assumed nor accepted for any damages, losses or costs resulting
from the use of the product. Any claims arising from the operating, failure or malfunctioning etc. will be denied. We
assume no liability for personal injury, property damage or consequential damages resulting from our product or
our workmanship. As far as is legally permitted, the obligation to compensation is limited to the invoice amount of
the affected product.
Specifications
Cont
Model
Current
6A 6A
12A 12A
12AE 12A
15A 15A
20A 20A
30A 30A
40A 40A
40A-UBEC 40A
50A-UBEC 50A
60A-UBEC 60A
60A-UBEC 60A
80A-UBEC 80A
80A-UBEC 80A
Programmable Items (The option written in bold font is the default setting)
1. Brake Setting：Enabled / Disabled
2. Battery Type：Lipo / NiMH
3. Low Voltage Protection Mode(Cut-Off Mode)： Soft Cut-Off (Gradually reduce the output power) /Cut-Off
(Immediately stop the output power).
4. Low Voltage Protection Threshold(Cut-Off Threshold)：Low / Medium / High
1) For lithium battery, the battery cell number is calculated automatically. Low / medium / high cutoff voltage for
each cell is 2.85V/3.15V/3.3V. For example: For a 3S Lipo, when "Medium" cutoff threshold is set, the cut-off
voltage will be:3.15*3=9.45V.
2) For NiMH battery, low / medium / high cutoff voltages are 0%/50%/65% of the startup voltage (i.e. the initial
voltage of battery pack), and 0% means the low voltage cut-off function is disabled. For example: For a 6 cells
NiMH battery, fully charged voltage is 1.44*6=8.64V, when "Medium"cut-off threshold is set, the cut-off voltage
will be: 8.64*50%=4.32V.
5. Startup Mode：Normal /Soft /Super-Soft (300ms / 1.5s / 3s)
a) Normal mode is suitable for fixed-wing aircraft. Soft or Super-soft modes are suitable for helicopters. The
initial acceleration of the Soft and Super-Soft modes are slower, it takes 1.5 second for Soft startup or 3 seconds
for Super-Soft startup from initial throttle advance to full throttle. If the throttle is completely closed (throttle stick
moved to bottom position) and opened again (throttle stick moved to top position) within 3 seconds after the first
startup, the re-startup will be temporarily changed to normal mode to get rid of the chance of a crash caused by
slow throttle response. This special design is suitable for aerobatic flight when quick throttle response is needed.
6. Timing：Low / Medium / High,( 3.75°/15°/26.25°) Usually, low timing is suitable for most motors. To get higher
speed, High timing value can be chosen.
Burst
BEC BEC
Current
Mode Output
(≤10)
2S Lipo 3S Lipo 4S Lipo 6S Lipo
8A Linear 5V/0.8A 3servos
15A Linear 5V/1A 3servos
15A Linear 5V/2A 5servos
20A Linear 5V/2A 5servos
25A Linear 5V/2A 5servos
40A Linear 5V/2A 5servos
55A Linear 5V/3A 5servos
55A Switch 5V/3A 5servos
65A Switch 5V/5A 8servos
80A Switch 5V/5A 8servos
80A N/A N/A
100A Switch 5V/5A 8servos
100A N/A N/A
BEC Output Capability
2servos
4servos
4servos
4servos
4servos
4servos
5servos 5servos
8servos 6servos 6servos
8servos 6servos 6servos
8servos 6servos 6servos
12
Battery Cell
Weight
Lipo NiMH
2S 5-6 cells 5.5 32*12*4.5
2-3S 5-9 cells 9g
2-3S 5-9 cells 10g
2-3S 5-9 cells 16.5g 48*22.5*6
2-3S 5-9 cells 19g
2-3S 5-9 cells 37g
2-3S 5-9 cells 39g
2-4S 5-12 cells 43g 65*25*12
2-4S 5-12 cells 41g 65*29*10
2-6S 5-18 cells 63g 77*35*14
2-6S 5-18 cells 60g 86*38*12
2-6S 5-18 cells 82g
86*38*12
2-6S
5-18 cells 79g 86*38*12
Weight
L*W*H
(mm)
38*18*6
38*18*7
42*25*8
68*25*8
68*25*8