Saving Energy; Before Using For The First Time; Electrical Connection - Thermador T24IW901SP Guide D'utilisation Et D'entretien

en-us Installation and connection

Saving energy

If you follow the instructions below, your appliance will use less power.
Note: The arrangement of the fittings does not affect the energy consumption of the appliance.
Installing the appliance
Keep the appliance out of direct sunlight.
Install the appliance as far away as possible from heating elements,
cooker and other heat sources:
At least 1¼" (3 cm) from electric or gas cookers.
At least 11¾" (30 cm) from oil or solid-fuel cookers.
Select an installation location at a room temperature of approx. 68 °F
(20 °C).
Do not cover or block the ventilation openings.
Ventilate the room daily.
Using the appliance
Open the appliance door only briefly.
Transport cooled wine in a cool bag and place in the appliance
quickly.
Always leave a space between the bottles and the back panel.
Do not cover or block the ventilation openings.
Vacuum the ventilation openings once a year.
--------

Before using for the first time

Remove information material, adhesive tape and
1.
protective foil.
Clean the appliance.
2.
~ "Cleaning" on page 18

Electrical connection

9
CAUTION
Do not connect the appliance to electronic
energy saver plugs.
Note: You can connect the appliance to mains-
controlled and sine-controlled inverters.
Mains-controlled inverters are used for photovoltaic
systems which are connected directly to the national
grid. Sine-controlled inverters must be used for
isolated applications. Isolated applications, e.g. on
ships or in mountain lodges, are not directly
connected to the national grid.
After installing the appliance, wait at least 1 hour
1.
before connecting it to prevent damaging the
compressor.
Check that the outlet was installed according to
2.
the regulations and complies with the
requirements.
6
The appliance needs to cool less frequently at low ambient tempera-
tures and therefore consumes less power.
The appliance needs to cool less frequently if the warm air can
escape and therefore consumes less power.
The air in the appliance does not warm up so intensely. The appliance
needs to cool less frequently and therefore consumes less power.
The air can circulate, and the temperature will remain constant. The
appliance needs to cool less frequently and therefore consumes less
power.
The appliance consumes less power if the warm air can escape freely.
Requirements for outlets
Outlet with
Protective conductor
Fuse
Maximum simultaneous load
Appliance
Connect the appliance to an outlet near the
3.
appliance.
The outlet must also be freely accessible
following installation of the appliance.
9
WARNING
RISK OF ELECTRIC SHOCK!
Never use multiple outlets, extension leads
or adapters.
The appliance must be grounded correctly.
Never cut through or remove the power
cord's third conductor (grounding
conductor).
9
WARNING
RISK OF ELECTRIC SHOCK!
If the power cord is too short, never use
multiple outlets or extension leads.Instead,
please contact Customer Service.
110 V ... 120 V
60 Hz
10 A ... 16 A
6 A