Dip-Switches - DITEC RO2H Manuel D'installation

1.5 Dip-Switches

GB
Description
DIP1 Opening with overlap.
1.6 Segnalazioni
LED
POWER
SIG
IN
1.7 Radio programming
Follow the instructions in the related manual to program the radio transmitter.
1.8 Single and centralised multilevel commands
The shutters of the house can be opened and closed with a single command, or by means of centralised multilevel commands
(room commands, floor or zone commands and general commands), by making the connections indicated in fig. 2.
2. STARTING
2.1 Set the application as indicated in paragraphs 1.4 and 1.5.
2.2 Connect possible remote and centralised controls.
2.3- Turn on the power.
2.4 Give opening and closing commands and check the correct movement of the automation.
Note: the automation will stop if an obstacle is present.
2.5 Check that the radio transmitters are functioning correctly if installed.
2.6 Check that the blocking devices are functioning correctly if installed.
2.7 (RADIUS only) Once the start and control has been completed, dismantle the arms, fix the profile lid and assemble the arms
again. Close the automation.
Note: tighten the screws that secure the arms to the motors so that the force of the motor when operating does not cause
the arm to slip. Also check if it is possible to move the wings manually with the power off.
(OLLYE only) The automation is not reversible, but to guarantee suitable locking during the night, a locking device must be
installed.
RO2H - IP1918
Right leaf overlapping the left leaf.
ON
Power supply on.
Indicates the transmitters enabling/memorisation
phase.
Indicates the reception of a command or a varia-
tion of the dip-switch and jumper.
OFF
Left leaf overlapping the right leaf.
Indicates the reception of a radio transmission.
8
ON
Blinking
/
/