SCHOLTES CI 66 V W S Mode D'emploi page 23

Start-up and use
Setting the clock
! The clock may be set when the oven is switched off
or when it is switched on, provided that the end time of
a cooking cycle has not been programmed previously.
1. Press the button several times until the
and the first two numerical digits on the display start to
flash.
2. Turn the TIMER KNOB towards "+" and "-" to adjust
the hour value.
3. Press the button again until the other two digits
on the DISPLAY begin to flash.
4. Turn the TIMER KNOB towards "+" and "-" to adjust
the minute value.
5. Press the button again to confirm.
Setting the timer
! This function does not interrupt cooking and does not
affect the oven; it is simply used to activate the buzzer
when the set amount of time has elapsed.
1. Press the button several times until the
and the three numerical digits on the DISPLAY begin to
flash.
2. Turn the TIMER KNOB towards "+" and "-" to adjust
the minute value.
3. Press the button again to confirm.
The display will then show the time as it counts down.
When this period of time has elapsed the buzzer will be
activated.
Using the oven
! Before operating the product, remove all plastic film
from the sides of the appliance.
! The first time you use your appliance, heat the empty
oven with its door closed at its maximum temperature
for at least half an hour. Make sure that the room is well
ventilated before switching the oven off and opening
the oven door. The appliance may emit a slightly
unpleasant odour caused by protective substances
used during the manufacturing process burning away.
1. Select the desired cooking mode by turning the
SELECTOR knob.
2. The oven begins its preheating stage and the
preheating indicator lights up.
The temperature may be changed by turning the
THERMOSTAT knob
*
Only available in certain models.
3. When the preheating indicator
a buzzer sounds the preheating process is complete:
you may now place the food in the oven.
4. During cooking it is always possible to:
- Change the cooking mode by turning the SELECTOR
icon
knob.
- Change the temperature by turning the
THERMOSTAT knob.
- Set the cooking duration and the cooking end time
(see Cooking modes).
- Stop cooking by turning the SELECTOR knob to the
"0" position.
5. The cooking time may be modified (see Cooking
Modes).
6. If a blackout occurs while the oven is already in
operation, an automatic system within the appliance
will reactivate the cooking mode from the point at
which it was interrupted, provided that the temperature
has not dropped below a certain level. Programmed
cooking modes which have not started will not be
restored and must be reprogrammed.
! There is no preheating stage for the ROASTING
modes.
icon
! Never put objects directly on the bottom of the
oven; this will prevent the enamel coating from being
damaged.
! Always place cookware on the rack(s) provided.
Cooling ventilation
In order to cool down the external temperature of the
oven, a cooling fan blows a stream of air between the
control panel and the oven door. At the beginning of
the PYROLYTIC cycle, the cooling fan operates at low
speed.
! Once cooking has been completed, the cooling fan
remains on until the oven has cooled down sufficiently.
Oven light
When the oven is not in operation, the lamp can be
switched on at any time by opening the oven door.
switches off and
WARNING! The oven is
provided with a stop sys-
tem to extract the racks
and prevent them from
coming out of the oven.(1)
As shown in the drawing,
to extract them comple-
tely, simply lift the racks,
holding them on the front
part, and pull (2).
23
GB