Télécharger Imprimer la page

Metabo PowerMaxx PA 12 LED-USB Notice D'utilisation page 11

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
Separate the heated jacket after use from the
Power Adapter.
After a period of 7 hours, the Power Adapter will
switch off automatically.
12V connector is only intended for use with the
Metabo heated jacket HJA 14.4-18.
5.4
Removal of the battery pack (8)
Hold the battery pack (8) with both hands at the body
and press hard with both thumbs against the cover
glass ofthe LED lamp (1). Push the Power Adapter
axially towards the back away from the battery
pack.The tight fit of the battery pack is required to
avoid unintentional removal/falling off when using the
heated jacket.
6. Faults
A connected load that is too high at the outputs
(permanently greater than 25W) can lead to
overheating of the Power Adapter. The overload
safety device temporarily then reduces the output
current.
In order to prevent overloads, check the combination
of the connecting devices so that the connected
continuous output adds up to less than 25W.
Read the actually required connection cables/current
in the operating instructions of your device.
In order to avoid electro-magnetic interferences, use
only USB cables not exceeding 1.0 m in length, and
which have a magnetic interference filter.
7. Cleaning
Remove the battery pack from the device before
carrying out cleaning.
Do not clean with aggressive cleaning agents.
Ensure that the device and the battery contacts are
dry before inserting the battery pack.
8. Repairs
Repairs to the device must only be carried out by
qualified electricians.
If you have Metabo devices that require repairs,
please contact your Metabo service centre. See
www.metabo.com for addresses.
9. Environmental Protection
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Only for EU countries: never dispose of power
tools in your household waste! Used power
tools must be collected separately and handed
in for environmentally compatible recycling in accord-
ance with European Directive 2012/19/EU on waste
electrical and electronic equipment and its implemen-
tation in national legal systems.
11

Publicité

loading