Menu; Starting Up - Lofrans GALAXY 703 Manuel D'installation Et D'utilisation

4 MENU

4.1 Starting up

The chain counter features a graphic display and three keys:
is also a buzzer that indicates the pressing of the keys or attracts the user's attention in particular conditions
(alarm triggering). The ON key switches on the display and enables the other two keys. It must be used to
access the parameter setting menus. For selecting the parameters to be modified and to confirm the values
set. The display backlight will switch off 60 seconds after the last command given (adjustable default time – see
"BkLight Time").
The UP key commands the hoisting of the anchor and the DOWN key casts it. When the key is released, the
action is stopped. During parameter setting, the two keys allow the User to move around the menu and vary
parameter values.
When switched on, the instrument will make a beep and the following page will appear for a few seconds:
Once the initialisation procedure is complete, the main page will appear.
Where:
STATUS: indicates the status of the instrument and any failure.
SPEED': indicates the chain speed during hoisting or lowering in meters per minute or feet per minute.
COUNT: indicates the measurement of the chain lowered (in metres or feet).
MONITORING: indicates the power supply voltage of the instrument and the power supply voltage of the boat.
ICONS: this is the part of the display bearing the icons that indicate the hoisting or casting of the anchor and any failure.
When the instrument is turned on for the first time, it will set up as programmed in the factory (see table).
4.2 Chain counter setting menu
Hold down the
access the instrument setting menu. The following
page will appear on the display:
Use the
move around the menu options.
Once you are positioned on the item to be modified press the
Use the
Once one is positioned on the parameter press the
According to the type of parameter, using the
reduce/increase the value of the same or disable/enable the function.
Once the modification has been performed, press the
Using the
the setting menu. The same procedure must be used to return to the main page.
6
www.busse-yachtshop.de | info@busse-yachtshop.de
V=11.6 Vdc
(ON) key for six seconds to
(DOWN) and (UP) keys to
(DOWN) or (UP) keys to move from one parameter to another.
(DOWN) key go to the Exit option and press the
(ON), (UP) and
Menu
M e a s u r e
A l a r m s & F u n c t i o n
S e t t i n g s
L a n g u a g e
S e n s o r C a l i b r a t i o n
(ON) key to confirm your choice.
(ON) key to enable modification.
(DOWN) and (UP) keys it is possible to
(ON) key to confirm.
(ON) key again to return to
GALAXY 703
(DOWN). There