Publicité
Les langues disponibles
Les langues disponibles
FABRIC
Denim
Varied ironing speed and fabric dampness might cause optimal setting to differ from that recommended in the
table!
TROUBLESHOOTING
PROBLEM
Soleplate is not heating even
though iron is turned on.
Iron does not produce
steam.
Steam jet and vertical steam
jet function does not work.
Water leaks from the
soleplate during ironing.
Flakes and impurities come
out of the soleplate during
ironing.
Water leaks from the
soleplate while the iron is
cooling down or after it has
been stored.
Brown streaks come out of
the soleplate while ironing
and stain the linen.
DISPOSAL
This symbol on the product indicates that this product contains a battery which shall not be disposed with
normal household waste.
This symbol on the product or on its packaging indicates that the product may not be treated as household
waste. To recycle your product, please take it to an official collection point or to an AEG service center that
can remove and recycle the battery and electric parts in a safe and professional way. Follow your country's
rules for the separate collection of electrical products and rechargeable batteries.
AEG reserves the right to change products, information and specifications without notice.
www.aeg.com
TEMPERATURE SETTING
to "MAX"
POSSIBLE CAUSE
Connection problem
Temperature control is in MIN
position.
Not enough water in tank.
Steam control is selected in non-
steam position.
Selected temperature is lower
than that specified to use with
steam.
Steam jet function was used very
frequently within a short period.
Iron is not hot enough.
The iron is not hot enough.
You have used hard water, which
has caused scale flakes to develop
in the water tank.
The iron has been put in
horizontal position while there is
still water in the water tank.
You have used chemical descaling
agents.
Fabric fibres have accumulated in
the holes of the soleplate and are
burning.
Fabrics might not be properly
rinsed or the garments are new
and have not been washed before
ironing.
IRONING RECOMMENDATION
Use maximum steam.
SOLUTION
Check main power supply cable, plug and outlet.
Select adequate temperature.
Fill water tank (see "Getting started", no 2).
Set steam control between positions of minimum
steam and maximum steam (see "Ironing chart").
Increase temperature to at least
Put iron on horizontal position and wait before
using steam jet function.
Adjust the proper temperature to steam ironing
(up to
). Put iron in vertical position and wait
until temperature indicator light turns off.
Set the temperature dial to a temperature
(
to maximum) suitable for steam ironing. Put
the iron on its heel and wait until the light has
gone out before you start ironing.
Press and hold the steam button for about one
minute to get steam. Then hold one more minute
in order to clean the steam generating system.
Iron an old towel, to ensure that any residues
inside the iron are not transferred to the laundry.
Empty the water tank and set the steam control
to position off before storing the iron.
Do not use any descaling agents.
Clean the soleplate with a damp soft cloth.
Please rinse the laundry properly again.
GB
DE
AR
ES
FA
FR
GR
NL
PT
.
9
Publicité
