Dicota DataDesk 450 Mode D'emploi page 6

User Manual DataDesk 450
Dear Customers,
We would like to thank you that you bought a DICOTA product. Before you use your DataDesk 450 for the first time please read the following
user manual thoroughly. The DataDesk 450 is suitable for the currently available printer model HP DJ 450. Please consult your local dealer or
the product detective at www.dicota.com to find out which Notebooks are suitable.
Table of contents
Table of contents
General information
- Work enviroment
- Operating voltage
Combination lock / scope of supply
Interior equipment
- Case lid
- Case bottom
Installation of your printer
Installation of your Notebook
Connection: Notebook - printer
General information - DataDesk 450
General information - DataDesk 450
Work enviroment
Please make sure that your DataDesk 450 is always operated on a steady, non-skid surface. Especially avoid working surfaces in dusty or damp environments!
→ When opening your DataDesk 450 attaché case, please make sure that the case shell with the case handle is upside!
→ If you would like to use your DataDesk 450 without the upper case shell, you can remove it as follows: Open the attaché case at an angle of approx. 60° - 70°. At this angle
you feel a slight resistance and you can detach the case lid by pulling it horizontally to the right.
→ Avoid the use of your DataDesk 450 near extreme heat sources (e.g. heaters). Protect your DataDesk 450 from direct sun irradiation!
→ For exact information regarding the temperature of the work environment, please refer to the user's guide of your Notebook or printer manufacturer.
→ The equipment should only be operated when the case is opened.
→ The case should not be immediately closed after the equipment has been used for a long period of time, so as to ensure a cooling-off period!
5
5
6
6
7
7
7
7
8
8
5