Domo DO2332CG Mode D'emploi page 38

PARTS
1. Observation window
2. Safety interlock system
3. Glass tray
4. Turntable ring assembly
5. Turntable shaft
6. Control panel
7. Grill rack
8. Display
9. Microwave/grill/combi/convection
setting
10. Defrost function
11. Setting the clock
12. Stop button
13. Start button
14. Turning knob
15. Protection cover wave guide - never remove
this cover!
BEFORE THE FIRST USE
TURNTABLE INSTALLATION
1. First place the turntable ring in the middle of the microwave oven.
2. Place the turntable on the ring. Make sure that the middle of the turntable fits
into the turntable shaft.
CAUTION:
· Never place the glass tray upside down. The glass tray should never be restricted.
· Both glass tray and turntable ring assembly must always be used during cooking.
· All food and containers should be placed onto the glass turntable during cooking at all times.
· If the glass tray or turntable ring assembly cracks or breaks, contact your nearest authorized service
center.
INSTALLATION
· Check the oven for any damage, such as dents or a damaged door. Do not use the oven if it is
damaged. Remove the protective film around the machine, this is applied to avoid scratches.
· Choose a place to install the microwave, where there is sufficient open space for the air intake and
exhaust.
The microwave oven must stand at least 85 cm high. Make sure that the left, right and back side are at
least 10 cm from the wall or cupboard. The open space above the microwave must be at least 20 cm.
· Never remove the feet from the underside of the oven.
38
DO2332CG
1
2
7
15
3
8
Waveguide
Cover
14
6
4
5
9
10
11
12
13