Imetec SCALDALETTO Instructions D'utilisation page 17

• Make sure the underblanket is always spread out smoothly and that there are no
creases.
• Make the bed, laying the mattress cover and/or the first sheet on top of the underblanket.
Place the second sheet and the normal blanket or duvet on top.
CONNECTING THE CONTROL UNIT
• Insert the control unit connector (2) in the underblanket connector (1) to connect the
control unit to the underblanket.
• For the double bed model, repeat the operation for the second control unit as well.
• Run the control unit cable along the floor next to the bed. Do not squash the control
unit cable between the mattress and the bed frame.
• Insert the plug of the control unit cable in the mains socket (3).
SWITCHING ON AND SELECTING THE RIGHT TEMPERATURE
The control unit can be set to the following temperature levels:
6: rapid preheating temperature
1-5: temperatures for continuous or night-time use
• Switch on the underblanket from the back of the control unit, by positioning the switch ON 'I'
(11).
• For rapid preheating of the bed, press the temperatures selector (9) until LED number 6 lights
up on the control unit.
IMPORTANT: The time needed for the underblanket to warm up will depend on the
room temperature. The temperature of the underblanket must be evaluated by lying
in the bed rather than just feeling it by hand.
NIGHT-TIME OR CONTINUOUS USE
For night-time or continuous use of the appliance, set the control
unit to temperature levels from 1 to 5 only.
• Press temperature selector (9) to select your preferred all night temperature setting
from 1 to 5 until the desired led lights up (6). The higher the number, the higher the
temperature.
• If the controller is in stand by mode, to switch it on again you first need to reset by first
switching off 'O' from the back (11).
EN
16