Publicité
Les langues disponibles
Les langues disponibles
It is not intended for use in farm accommodation or Bed & Breakfast
establishments.
Instructions
Preparation
Before using for the first time, boil fresh water at least three
times in the appliance. Use only water without any additives or
ingredients.
Mains Lead
Completely unwind the length of mains lead that you require
from the bottom section of the base. Please ensure that the
mains lead does not become tangled up.
Electrical connection
Check whether the electrical voltage that you intend to use is
the same as that of the machine. Details are to be found on the
label on the base.
Connected Wattage
The total power consumption of this device can be up to 2200 W.
With this connected load a separate supply line protected by a
16 A household circuit breaker is recommended.
CAUTION: Overload!
•
If you use extension leads, these should have a cable
cross-section of at least 1.5 mm².
•
Do not use any multiple sockets, as this device is too
powerful.
Switching on/off
Switch on:
Set the toggle switch in the handle to the "I"
position. The indicator lamp beneath the switch
will light up.
Switch off:
Set the toggle switch to the "0" position. The
indicator lamp beneath the switch will go out.
Use
NOTE:
Always use fresh, cold water.
1. Place the machine on a flat surface.
2. Press the button in the lid to open the kettle. The opener
will spring open. You may remove the lid.
3. Then fill in the water. Please only fill up to the maximum
(MAX) mark. You can read the filling level on the water
level indicator of the kettle.
4. Put the lid onto the appliance. Press the button in the lid to
close it. The button must click in audibly.
5. Place the kettle flush on the base.
6. Only connect the machine to a properly installed safety
socket.
7. Switch on the kettle by pressing the switch. To control lamp
lights up.
Pausing/ terminating operation
There are two options to interrupt the boiling process or to
terminate it:
•
The appliance will shut off automatically after the boiling
process. The indicator lamp will go out.
•
Set the switch to the "0" position to pause or terminate the
boiling process.
WARNING:
•
Do not remove the appliance from the base without
shutting it off first. As long as the switch is in the "I"
position, the kettle will stay turned on.
•
Always shut off the appliance before removing it from the
base! Also ensure that it is turned off when you set it back
onto the base!
WARNING: Danger of scalding!
•
When pouring the water out, keep the lid closed.
•
During operation the housing becomes hot. Do not touch
it and allow the device to cool down before storing it
away.
•
Disconnect the power cord.
•
Emptying the water container.
Mains Cable Take-up Device
The mains cable can be wound up on the base.
Cleaning
WARNING:
•
Always turn the device off before cleaning it and remove
the mains plug. Wait until the device has cooled down.
•
Never immerse the device or the base in water or other
liquids.
CAUTION:
•
Do not use any wire brush or other abrasive objects.
•
Do not use any acidic or abrasive detergents.
•
Clean the perforated area of the spout from the inside with
a nylon brush.
•
Rinse the water container out with clean water. Then dry it
off with a cloth.
•
Clean the housing after use with a slightly damp cloth.
29
Publicité
