Publicité
Les langues disponibles
Les langues disponibles
You can choose one of 12 directions of the skirt in
accordance with your purpose.
1
012885
To remove the skirt, remove the screw and remove the
skirt with slightly opening it for both sides.
012945
To reinstall the skirt, install it with slightly opening it for
both sides. And fasten the screw.
CAUTION:
Do not set the skirt other than the designated angle.
Otherwise the tool may be damaged.
OPERATION
WARNING:
Never switch on the tool when it is in contact with the
workpiece, it may cause an injury to operator.
Sanding operation
012879
CAUTION:
Never run the tool without the abrasive disc. You
•
may seriously damage the pad.
Never force the tool. Excessive pressure may
•
decrease the sanding efficiency, damage the
abrasive disc or shorten tool life.
1. Skirt
2. Screw
2
1. Skirt
1
Using the tool with the pad edge contacting the
•
workpiece may damage the pad.
Hold the tool firmly. Turn the tool on and wait until it
attains full speed. Then gently place the tool on the
workpiece surface. Keep the pad flush with the
workpiece and apply slight pressure on the tool.
CAUTION:
The sanding pad rotates clockwise during the loaded
operation, but it may rotate counterclockwise during the
no-load operation.
Polishing operation (optional)
CAUTION:
Use only a Makita genuine sponge pad, felt pad or
•
wool pad (optional accessories).
Always operate the tool at low speed to prevent
•
work surfaces from heating abnormally.
Never force the tool. Excessive pressure may
•
decrease the polishing efficiency and cause motor
overload, resulting in tool malfunction.
1.
Applying wax
1
012882
Use an optional sponge pad. Apply wax to the
sponge pad or work surface. Run the tool at low
speed to smooth out wax.
NOTE:
First, wax a not conspicuous portion of the work
•
surface to make sure that the tool will not scratch
the surface or result in uneven waxing.
The tool starts with high speed mode. Be careful
•
when you start the tool. The wax may be spattered.
It is recommended that you spread wax with the
tool stopped before starting up the tool. Change
the speed mode to low immediately after you start
the tool.
Always run the tool at low speed. Running it at high
•
speed may cause the wax to spatter.
7
1. Sponge pad
Publicité
