Troubleshooting - Indesit IDC 75 Mode D'emploi

Troubleshooting

If you feel that the dryer is not working properly, consult the following troubleshooting suggestions before contacting the Technical
(see Assistance).
Assistance Centre
Problem:
The dryer does not start.
Drying times are too long.
The dryer is noisy during the first
few minutes of operation.
Possible causes / Solutions:
• The plug has not been inserted far enough into the socket to make contact.
• There has been a power cut.
• The fuse has blown. Try connecting another appliance to the same socket.
• If an extension cord is used, try connecting the dryer plug directly into the socket.
• The door has not been closed properly.
• The programme has not been set correctly (see How to carry out a drying cycle).
START
• The button has not been pressed (see How to carry out a drying cycle).
• The filter has not been cleaned (see Care and maintenance).
• The water container must be emptied? The "Empty water container" indicator light is
on (see Care and maintenance).
• The condenser needs to be cleaned (see Care and maintenance).
• An incorrect drying time was selected for the type of load (see Laundry).
• The air intake grille is blocked (see "Installation" and "Care and Maintenance").
• The items are too wet (see Laundry).
• The dryer is overloaded (see Laundry).
• This is normal, especially if the dryer has not been used for a long time. If the noise
persists during the entire cycle, contact the Technical Assistance Centre.
EN
11