Stiga TITAN 740 DC Mode D'emploi page 88

EN
Depending on the implement used,
counter weights might have to be
mounted on the machine. The axle
pressure of a wheel axle may never
exceed 900 kg or 70% of the total
weight of the machine
5.11 STOP
Disengage PTO. Apply the parking brake.
Allow the engine to idle 1 - 2 mins. Stop the engine
by turning off the starter key.
If the machine is left unattended,
remove the ignition key.
The engine may be very hot
immediately after it is shut off. Do not
touch the silencer or other engine parts.
This can cause burn injuries.
5.12 CLEANING
To reduce the risk of fire, keep the
engine, silencer, battery and fuel tank
free from grass, leaves and oil.
To reduce the risk of fire, regularly
check the machine for oil and/or fuel
leakage.
Never use high-pressure water. This can
damage shaft seals, electrical
components or hydraulic valves.
Never use high-pressure air against the
radiator fins. This will damage the fin
structure.
Clean the machine after use. The following in-
structions apply to cleaning:
• Do not point jets of water directly at the engine.
• Clean the engine with a brush and/or com-
pressed air.
• Clean the engine's radiator (8:R) and condenser
(8:S) with a soft brush. Large objects can be re-
moved by hand. If the coolers are heavily
soiled, clean using slow running water and a
suitable detergent.
• After cleaning with water, start the machine and
any cutting deck to remove the water that may
otherwise penetrate bearings and cause damage.
6 MAINTENANCE
6.1 SERVICE PROGRAM
In order to keep the machine in good condition, as
regards reliability and operational safety as well as
from an environmental perspective, the service in-
structions in this section should be followed.
All services should be carried out by authorised
workshops.
88
ENGLISH
Service, carried out by authorised workshops,
guarantees a professional job with original re-
placement parts.
The service log should be stamped at every service
carried out by an authorised workshop. A "fully
stamped" service log is a valuable document that
improves the machine's second-hand value.
The service points are given in the table below. De-
scriptions of how the procedures are to be carried
out are given after the table.
6.2 SERVICE POINTS
Service point
Water separator,
check
Pre-filter, cleaning
Fuel filter, replace
Tyre pressure,
check, adjust
Engine oil, filter,
change
Hydraulic oil, fil-
ter, tank vent valve,
change/clean
Wheel motors ,
change oil
Belt transmissions,
check
Cooling system,
clean
Battery, check
Air filter, clean pre-
filter
Air filter, change
inner filter
Lubrication
Adjusting valves
Grinding valves
6.3 PREPARATION
All service and all maintenance must be carried out
on a stationary machine with the engine switched
off.
Prevent the machine from rolling by
always applying the parking brake.
Stop the engine.
Prevent unintentional starting of the
engine by removing the ignition key.
Original instructions for use
.
1st time Interval
para-
Hours of operation/
graph
Calendar months
50/-
400/-
50/12 200/12
50/12 400/12
50/12 200/12
50 200/-
1000/12
50/-
250/-
250/-
1000/-
2000/-
See
6.4
6.4
6.5
6.6
6.7
6.8
6.9
6.10
6.11
6.12
6.13
6.13
6.14
6.15
6.15