König SAS-ASDW4 QIG Série Manuel De L'utilisateur page 4

SAS-ASDW4xx - QIG
Door/window sensor
Description
1. Transmitter
2. LED indicator
The LED indicator flashes once: the transmitter is triggered and sends a signal to the
control panel.
The LED indicator is on 'Low battery': Replace the battery.
3. Magnet
Installation
- Remove the battery activation strip.
- Install the transmitter to the frame of the door or window using double-sided
adhesive tape or screws.
- Install the magnet to the door or window using double-sided adhesive tape or screws.
- Make sure that the magnet is aligned correctly to the transmitter (markings on the
magnet and the transmitter) within 1 cm from each other.
Pairing the door/window contact to the main unit
1. On the main unit, long press the numbered button (1 - 4) matching the zone you want
to add the detector to. The corresponding LED lights up.
2. Power and/or trigger the detector you want to add.
a. Two flashes and two tones indicate successful pairing.
b. Single flash and tone indicate known accessory.
c. Three flashes and tones indicate no more detectors can be added
3. If a detector is triggered, the corresponding zone indicator LED flashes
4. For further details check the SAS-ALARM400 manual
Technical data
Power supply:
Transmission range:
Frequency:
Operating temperature:
Relative humidity:
Dimensions:
- Transmitter:
- Magnet:
12 VDC 23 A (included)
up to 100 m
433 MHz
0 °C ~ +40 °C
< 80% (non-condensing)
76 x 36 x 16 mm
55 x 13 x 20 mm
4