WamBlee W420 Manuel D'instruction page 43


For the W420LP model, the flash light will start flashing slowly (1
flash per second). Release the pressure from the 'Test/Activation'
pushbutton.

Your device will try to obtain the position in the next 5 minutes.

If the position is acquired before five minutes, the flash will start
and an AIS test transmission will be performed as confirmation to
the fix found (W420 only).

For the W420LP, if the position is acquired before five minutes, the
buzzer make a short bip as confirmation to the fix found.

If the position isn't acquired within 5 minutes the flash will start and
an AIS test transmission – with the default paramiters (without the
position) - will be performed as confirmation of the fix reception
failure (W420 only).

For the W420LP, if the position isn't acquired within 5 minutes an
AIS test transmission – with the default paramiters (without the
position) - will be performed as confirmation of the fix reception
failure.
ID code
The ID code is reported on the external label on the back plane of your
W420(LP/EX) Personal AIS Beacon device. This code is fixed in the device and
cannot be changed by the user.
Compatibility with AIS Chart plotter system
The W420(LP/EX) Personal AIS beacon works as an AIS SART unit. Please
verify with the chart plotter or AIS receiver manufacturer that your AIS unit is
able to properly receive the AIS message type 14 (AIS SART).
Changing the batteries
The supplied batteries must be changed 5 years after their installation.
Batteries must only be of the specific models approved by WamBlee;
installation of unapproved models may involve the malfunction or
breakdown of the device .
EN
43