Toto Aimes TL626DD Manuel D'installation Et D'utilisation page 5

5) Use needle nose pliers to rotate the
cold valve stem counterclockwise as far
as possible. Install the cold handle as-
sembly onto the cold deck adapter with
the long end of the handle pointing to
the right. Secure the handle assembly
with the set screw.
Use needle nose pliers to rotate the hot
valve stem clockwise as far as possible.
Install the hot handle assembly onto the
hot deck adapter with the long end of
the handle pointing to the left. Secure
the handle assembly with the set screw.
6) Connect the outlets on the
valve bodies to the spout shank
with the included flex hoses.
Connect the supply lines (not
included) to the inlets on the
valve bodies.
7) Install the drain as shown in the
illustration, and connect the lift
rod at the connecting block.
Installation Procedure (continued)
Hot Flex Hose
1/2" NPSM Water Supply Lines
(not included)
Stopper
Flange
Pipe Tape
Flange Nut
Locknut
Tail Piece
Drain Body
5
Handle
Set Screw
Cold Flex Hose
Connecting
Block
Gasket
Spring
Gasket
Nut
Pivot Rod
Seal