Hitachi UC 24YFA Instructions De Sécurité Et Mode D'emploi page 8

English
SPECIFICATIONS
Input power source
Charging time
Charger
Weight
APPLICATIONS
For charging the HITACHI batteries types EB7, EB9, EB12, EB14, EB18 series and EB24B.
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
EB9
EB12
EB9S
EB12S
EB7
EB9B
EB12B
Fig. 2
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in Fig. 2. Make sure it contacts the
bottom of the battery charger.
8
Single phase: AC120V 60Hz
Approx. 35 minutes ............. EB7, EB9, EB9S, EB12, EB12S
Approx. 50 minutes ............. EB9B, EB12B, EB14B, EB18B,
Charging voltage .......................... DC 7.2–24V
Charging current ........................... DC 2.5A
1.3 lbs (0.6kg)
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn up.
EB1820
EB14B
EB18B
EB24B
EB1820, EB24B
1. Insert the plug of battery charger into
the receptacle.
When the plug of battery charger has been
inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical
cord if damaged. Have it
repaired immediately.