Remote Control; Connecting To Power; Power Supply - Roadstar HIF-1899TUMPK Manuel D'instructions

30) TAPE BUTTON
31) PHONO BUTTON
32) CD STOP BUTTON
33) TAPE FF/EJECT BUTTON
34) TAPE SLOT-IN
35) TOP COVER MECHANISM
36) TURNTABLE

REMOTE CONTROL

BATTERY INSTALLATION
the infra-red transmitter requires 2 pcs CR-2025 size battery for operation.
37) OPEN / CLOSE CD DOOR.
38) RECin cd or phono mode, press to active
recording function.
39) REPEAT BUTTON
40) PLAY/PAUSE in cd/usb mode, press
once to start playback. press again to enter
pause mode.
41) skip/search backward press once
to skip to previous tack.press & hold for search
backward.
42) SKIP/SEARCH forward press once to
skip to next track, press & hold for search
forward.
43) STOP in cd/usb mode, press to stop playback or cancel the stored program.
44) + 10 Track Button
45) - 10 Track Button
46) RANDOM BUTTON in cd/usb mode, press to active random function.
47) DELETE button
48) PROGRAM in CD/USBb mode, press to active programming function.
English
3
38
37
39
40
41
42
43
44
45
46
47
48
English
4

CONNECTING TO POWER

Before switching on make sure that the voltage of your electricity supply is the same as
that indicated on the rating plate.
For your own safety read the following instructions carefully before attempting to connect
this unit to the mains.
MAINS (AC) OPERATION
This unit is designed to operate on AC 230V 50Hz current only. Connecting it to other
power sources may damage the unit.
CAUTION
To prevent electric shock disconnect from the mains before removing cover. No user
serviceable parts inside. Refer servicing to qualified service personnel.
SAFETY PRECAUTION
Do not allow this unit to be exposed to rain or moisture.
Mains Supply: 230V 50Hz - AC only
This symbol means that this unit is double insulated. An earth connection is not
required.

POWER SUPPLY

Remove the stereo carefully from the box, retaining the packaging for future use.
AC POWER OPERATION
Connect the plug to a mains power inlet 230V AC ~ 50 Hz.
MW/FM TUNER
Operation
• Switch ON the Power Switch (15). The red Power Indicator (17) will light up.
Select the desired frequency band with the Band Selector
•
band.
• Tune to the desired radio station by turning the Tuning control (21).
ANTENNA
• For FM reception there is a built-in FM antenna wire (28) at the rear of the unit. Move the
wire around to obtain the best reception.
• For MW reception the signals are picked up through a built-in ferrite antenna. Your may
have to orient the unit to obtain the best reception.
(14) for FM or (12) for MW