Bosch PMD 7 Notice Originale page 19

OBJ_BUCH-1913-003.book Page 19 Tuesday, July 7, 2015 10:09 AM
Declaration of Conformity
We declare under our sole responsibility that the product described
under "Technical Data" conforms with all the relevant provisions of the
Directives 2011/65/EU and 1999/5/EC, including amendments, and
meets the following standards:
EN 61010-1:2010-10, EN 61326-1:2006-05, EN 301489-3:2002-08,
EN 301489-1:2011-09, EN 300330-1:2010-02,
EN 300330-2:2010-02.
Henk Becker
Executive Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
70764 Leinfelden-Echterdingen, GERMANY
Leinfelden, 16.06.2015
Assembly
Inserting/Replacing the Batteries
Alkali-manganese batteries are recommended for the operation of the
measuring tool.
To open the battery lid 5, press on the latch 4 and fold the battery lid up.
Insert the batteries. When inserting, pay attention to the correct polarity
according to the representation on the inside of the battery compartment.
 Remove the batteries from the measuring tool when not using it
for extended periods. When storing for extended periods, the
batteries can corrode and self-discharge.
Bosch Power Tools
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
2 609 141 285 | (7.7.15)
English | 19