ELNA eXperience 520 Mode D'emploi page 62

b
Step 1
Step 2
Step 3
Step 4
n
!1
!2
m
t
!0
!3
b Start the machine to sew the buttonhole.
The buttonhole will be automatically sewn.
Step 1: The machine will sew the front bartack and
the left row first.
Then it goes back to the starting point with
straight stitch.
Step 2: The machine will sew the right row.
Step 3: The machine will sew the back bartack.
Step 4: The machine will stop automatically and a dot
will blink !0 .
To sew another buttonhole, raise the presser foot.
Move the fabric to where the next buttonhole is to be
sewn, then lower the foot and start the machine.
If you start sewing the buttonhole without lowering the
buttonhole lever, the indicator will show a warning
sign.
Lower the buttonhole lever, then restart the machine.
NOTE:
If you select other pattern without raising the presser
foot or buttonhole lever after buttonhole sewing, the
indicator will show a warning sign.
Raise the presser foot and buttonhole lever, then
select the pattern.
n Remove the fabric and place a pin !1 just below
the bartack at each end to prevent accidentally
cutting stitches. Cut the opening with the seam
ripper !2 . Use an eyelet punch !3 to open a
keyhole buttonhole.
m When buttonhole sewing is finished, push the
buttonhole lever t upward as far as it will go.
56