Auto Control Or Top Zone; Leds And Pushbutton Actions Functioning - JRI Maxant Spy RF T+ Notice D'utilisation

j) Auto control or top zone
The type of action depends on the SPY RF configuration.
TOP ZONE = Transport mode
This function enables you to customise an action of measurement check-up. You just have to press shortly on
the pushbutton.
The action is recorded and will appear on the curve when you process the data with your software Sirius.
k) Leds and pushbutton actions functioning
The green led is on 2'' when the measurement starts and then flashes each 1' in recording mode.
Specials functioning regarding the recorder using mode
Device set up in storage mode
Pushbutton pressing
Mode
OFF
Starting measurements
Pushbutton
Delayed (date & time)
Immediately
Mesure
Device set up in transportation mode
Pushbutton pressing
Mode
Off
Starting measurements
Pushbutton
Delayed (date & time)
Immediately
Mesure
©JRI Maxant
and AUTO CONTROL = Storage mode
T° OK (voyant vert)
+
s'allume pendant 10''.
Témoin d'alarme (rouge)
+
s'allume pendant 10''.
< 5"
-
Green led 2" = beginning of
measurements
-
-
Green led 10" = auto control
< 5"
-
Green led 2" = beginning of
measurements
-
Green led 10" = Top zone
5''> pressing <10''
The 2 leds are on and
flash at the same time.
-
-
-
-
5"<appui>10"
The 2 leds are on and flash at
the same time
.
-
The 2 leds are on and flash at
the same time
= Waiting for
starting measurements
The 2 LEDs are on and then
flash alternatively
= ending
measurements
The 2 LEDs are on and then
flash alternatively
= ending
measurements
16