I. INTRODUCTION
Congratulations, you own a SPY RF T+ ! This device is equipped with 1 internal sensor. It enables you to record the ambient
temperature and to transfer wirelessly the recorded data by radio frequency to a PC.
The SPY RF T+ complies with EN 12830.
a)
Equipment
1 SPY RF T +
1 user manual
b)
Symbols
RECYCLING : do not throw in a rubbish dump or in a domestic waste container. Comply to the regulation to throw away the
device.
CE MARKING : this equipment is certified to comply with the European regulation for the electric security, inflammability,
disturbing radiation emission and immunity to surrounding electric disturbances.
FCC ID : W45 03330
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation
In accordance with FCC requirements, changes or modifications not expressly approved by JRI could void the user's
authority to operate this product.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
II. PRESENTATION
a)
Display
Recording mode
Overpassed
thresholds
indicators
Channel N°
©JRI Maxant
Alarm led (red)
Recording led(green)
Push button
Display
Waiting mode
Non-programmed
mode
Dilatation cap to
absorbe variation of
pressure
Memory status
Radio signal
Measurement
and unit
12