Festool QUADRIVE DRC 18/4 Notice D'utilisation D'origine page 12

DRC 18/4
GB
4 Machine features
[1-1] LED light switch
[1-2] LED lamp
[1-3] Bit store
[1-4] On/Off switch
[1-5] Clamping sleeve
[1-6] Gear switch
[1-7] Torque thumbwheel
[1-8] Right/left switch
[1-9] Belt clip
[1-10] Button for releasing the battery pack
[3-1] LED-Display
[3-2] Cable holder
[4] Wall mount
Accessories shown or described are sometimes not
included in the scope of delivery.
The specified illustrations appear at the beginning
of the Operating Instructions.
5 Intended use
Cordless drill suitable for
– drilling in metal, wood, plastic and similar mate-
rials,
– inserting and tightening screws
Charger TCL 3 suitable for
– charging Festool battery packs: BP, BPS and
BPC (NiMH, NiCd, li-ion are recognised automat-
ically.)
– indoor use only.
The user is liable for improper or non-in-
tended use; this also includes continuous in-
dustrial operation.
6 Operation
6.1 Charger cable holder[3-2]
Unwind the cable completely from the recess
before using the charger.
6.2 Changing the battery pack
Inserting the battery pack [2 A]
Removing the battery pack[2 B]
 Battery pack is ready for use immediately upon
delivery and can be charged at any time.
6.3 Charging the battery pack [3]
The LED [3-1] on the charger indicates the respec-
tive operating status of the charger.
LED yellow - lit continuously
Charger is ready to use.
12
LED green - flashes quickly
Battery pack is charged to maxi-
mum capacity.
LED green - flashes slowly
Battery pack is charged with
reduced current. Li-ion is
charged to 80 %.
LED green - lit continuously
Charging is complete or is not
restarted as current charge sta-
tus is greater than 80%.
LED red - flashes
General fault indication, e.g.
incomplete contact, short circuit,
defective battery pack, etc.
LED red - lit continuously
Battery temperature is outside
the permitted range.
6.4 Light and battery capacity indicator
The LED on the lamp [1-2] is both a light and
a battery capacity indicator .

Press the LED light switch [1-1]:
1x ... LED, working area illumination
2x ... capacity indicator, indicates the charging
state of the battery pack (not with NiCd and
NiMH battery packs)
LED green – lit continuously:
charged > 60 %
LED green – flashing slowly:
charged 30 % – 60 %
LED green – flashing quickly:
charged 0 % – 30 %
LED yellow – lit continuously:
battery is empty
LED red – lit continuously: bat-
tery temperature is outside the
permitted range.
LED red – flashing: indicates a
general fault, e.g. incomplete
contact, short circuit, battery
pack faulty, etc.
7 Settings
WARNING
Risk of injury

Always switch off the machine before adjusting
settings!