KRAFTWERK 38101 Manuel D'utilisation page 2

• READ, STUDY AND UNDERSTAND ALL WARNINGS AND OPERATION INSTRUCTIONS PRIOR TO USE.
• DO NOT OVERLOAD THIS JACK BEYOND THE RATED CAPACITY.
• THIS JACK IS DESIGNED FOR USE ONLY ON HARD LEVEL SURFACES CAPABLE OF SUSTAINING THE LOAD. USE ON
OTHER THAN HARD LEVEL SURFACES CAN RESULT IN JACK INSTABILITY AND POSSIBLE LOSS OF LOAD.
• THIS IS A LIFTING DEVICE ONLY. IMMEDIATELY AFTER LIFTING, SUPPORT THE VEHICLE WITH JACK STANDS.
• DO NOT GET UNDER OR ALLOW ANYONE UNDER THE VEHICLE UNTIL IT HAS BEEN SUPPORTED BY JACK STANDS.
• DO NOT MOVE OR DOLLY THE VEHICLE WHILE ON THE JACK.
• LIFT ONLY ON AREAS OF THE VEHICLE AS SPECIFIED BY THE VEHICLE MANUFACTURER
• CENTER LOAD ON SADDLE PRIOR TO LIFTING.
• NO ALTERATIONS TO THE JACK SHALL BE MADE.
• FAILURE OR HEED THESE WARNINGS MAY RESULT IN PERSONAL INJURY AND PROPERTY DAMAGE.
• THE PRESSURE VALVE HAS BEEN SEALED BY THE FACTORY. NEVER ADJUST THE PRESSURE VALVE BY YOURSELF
OTHERWISE YOU LOOSE YOUR GUARANTEE-RIGHT. CONTACT CUSTOMER SERVICE DEPARTMENT TO LET SEAL THE
PRESSURE VALVE BY AUTHORIZED PEOPLE AT 2 TONS LIMITED ONLY.
• IT IS FORBIDDEN TO USE THE JACK TO LIFT UP PEOPLE.
• STATIC ELECTRICITY IS A PHYSICAL PHENOMENON THAT CAN ADVERSELY AFFECT THE OPERATION OF THE JACK.
THEREFORE, THE USER MUST ENSURE THAT THE MOVING PARTS OF THE JACK ARE CLEAN.
• IT IS FORBIDDEN TO LIFT UP OR HOLD A LOAD EXPOSED TO STRONG WINDS.
• THE MARKING MUST BE KEPT IN ITS ORIGINAL STATE.
DONT USE THE TROLLEY JACK:
• IN DIFFICULT CONDITIONS (FOR EXAMPLE IN COLD WEATHER, IN HOT WEATHER OR UNDER THE INFLUENCE OF A
STRONG MAGNETIC RADIATION AND OTHER EQUIVALENT CIRCUMSTANCES).
• IN CONTACT WITH EXPLOSIVE MATERIALS, MINES AND SIMILAR MATERIALS
• FOR LIFTING OF UNSUITABLE PRODUCTS, WHICH CONTAIN AMONG OTHERS: MOLTEN METALS, ACIDS, RADIOACTIVE
MATERIALS OR BULK MATERIALS NOT HELD TOGETHER, AND OTHER SIMILAR MATERIAL.
• IN CONTACT WITH FOOD AND EQUIVALENTS.
• ON BOATS AND OTHER SIMILAR SITUATIONS.
Because of potential hazards associated with the misuses of equipment of this type, no alterations shall be made to
the product without written authorization of KRAFTWERK as manufacturer and supplier.
WARNING
2