Installation Requirements; Tools And Parts - Whirlpool W10403810B Instructions D'installation

Table des Matières

Les langues disponibles

In the State of Massachusetts, the following installation instructions apply:

Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by

the State of Massachusetts.

If using a ball valve, it shall be a T-handle type.

A flexible gas connector, when used, must not exceed 3 feet.

Anti-Tip

Bracket

Range Foot

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed

here.

Tools needed

Tape measure

Flat-blade screwdriver

Phillips screwdriver

Level

Hand or electric drill

Hammer

Wrench or pliers

Pipe wrench

¹⁵⁄₁₆" combination wrench

¼" drive ratchet

³⁄₈" nut driver

¹⁄₈" (3.2 mm) drill bit (for

wood floors)

†® QUADREX is a registered trademark of NLW Holdings, Inc.

A child or adult can tip the range and be killed.

Install anti-tip bracket to floor or wall per installation instructions.

Slide range back so rear range foot is engaged in the slot of the anti-tip bracket.

Re-engage anti-tip bracket if range is moved.

Do not operate range without anti-tip bracket installed and engaged.

Failure to follow these instructions can result in death or serious burns to children and adults.

To verify the anti-tip bracket is installed and engaged:

• Slide range forward.

• Look for the anti-tip bracket securely attached to floor or wall.

• Slide range back so rear range foot is under anti-tip bracket.

• See installation instructions for details.