Cleaning And Maintenance - Melitta MPK001 Mode D'emploi

4. Lift the kettle from the power base and then
pour the water.
NOTE: operate carefully when pouring the
water from your kettle as boiling water may
result in scald, besides, don't open the lid
while the water in the kettle is hot.
5. The kettle will not re-boil until the switch is
pressed again. The kettle may be stored on
the power base when not in use.
NOTE: Always disconnect the power supply
when not use.
BOIL-DRY PROTECT
Should you accidentally let the kettle operate
without water, the boil-dry protection will
automatically switch off the power. If this
occurs, allow the kettle to cool before filling
with cold water before re-boiling.

CLEANING AND MAINTENANCE

Always disconnect the appliance from the power
outlet before cleaning.
● Never immerse the kettle, power cord or
power base in water, or allow moisture to
contact with these parts.
● Wipe the appearance of body with
a damp cloth or cleaner, never use
a poisonous cleaner.
CAUTION: Do not use chemical, steel, wooden
or abrasive cleaners to clean the outside of the
kettle to prevent the gloss loss.
● When not use or storage, the power cord may
be wound under the bottom of kettle.
REMOVAL OF MINERAL DEPOSITS
Your kettle should be periodically descaled as
the mineral deposits in tap water may form scale
on the bottom of kettle so as to cause the
operation less efficiency. You can use the
commercially available descaling agents and
follow the instructions on the package of
descaling agents. Alternatively, you may follow
below instructions using the white vinegar.
1. Fill the kettle with 3 cups of white vinegar,
thenadding water to the amount so as to
cover the bottom of kettle completely. Leave
the solution in the kettle overnight.
2. Then discard the mixture in the kettle, then fill
the kettle with clean water, boiling and then
discard the water. Repeat several times until
the odor of vinegar has been flushes away.
Any stains remaining inside the spout can be
removed by rubbing with a damp cloth.
LIMITED WARRANTY
In addition to the legal warranty claims, to which
the end user is entitled relative to the seller, for
this device, if it was purchased from a dealer
authorized by Wabilogic Inc. due to his
consulting competence, we grant a
manufacturer's warranty under the following
conditions.
● 1 year limited warranty from the date of
original purchase.
● This warranty extends only to the original
retail purchaser or gift recipient. Keep the
original sales receipt, as proof of purchase is
required to make a warranty claim.
● Defects that occur due to improper
connection, improper handling or repair
attempts by non-authorized persons are not
covered by the warranty. The same applies
for failure to comply with the use of
consumables (e.g. cleaning and descaling
agents) that do not correspond to the original
specifications. Wear parts (e.g. seals and
valves) and fragile parts are excluded from
the warranty.
● This device was designed and built for
household use only. It is not suited for
other uses.
● Warranty does not cover damages that are
not the responsibility of the manufacturer.
This is valid especially for claims arising from
improper use (e.g. operation with insufficient
current or improper voltage).
EN