Updating The Firmware; Notes About Dante; Names And Functions Of Parts; Rear Panel - Tascam IF-DA64 Mode D'emploi

Updating the firmware

Two separate types of firmware can be updated to add functions
to this card.
•
Card firmware
•
Dante module firmware
Both firmware updates must be conducted separately.
Check the TEAC Global Site (http://teac-global.com/) for details
about the latest firmware and update procedures.

Notes about Dante

Dante is a transmission protocol developed by Audinate. Using
networks based on gigabit Ethernet standards, it enables multi-
channel (512 IN/512 OUT) transmission and high precision, for
example.
Check the Audinate website for details about Dante.
https://www.audinate.com/
•
This card includes a Dante module circuit board made by
Audinate.
See the following Audinate web page for information about
the open source components used by the Dante module
circuit board.
https://www.audinate.com/software-licensing

Names and functions of parts

This card has two RJ-45 connectors that support gigabit Ethernet.
Use LAN cables to connect these connectors to other devices that
support Dante or a Dante network.

Rear panel

PRIMARY connector
1
This is the main Dante transmission connector.
Use this to connect to a Dante network all the time.
SECONDARY connector
2
This is the secondary Dante transmission connector. The use
changes depending on the mode.
When in redundant mode, this connects to the secondary
Dante network.
7
TASCAM IF-DA64