PLYMOVENT MINIMAN-100 ATEX Manuel Opérateur page 6

MiniMan
A. If the inner arm seems to be too weak or too strong:
check that the arm is correctly assembled on the wall. Also
1.
check that the wall bracket is level.
Check and adjust the friction joints marked A on the figure.
2.
B. If the outer arm will not stay in the required position:
check that the arm is correctly assembled. Also check that
1.
the wall bracket is level.
Check and adjust the friction joints marked B on the figure.
2.
C. If the hood will not stay in the required position:
Adjust the friction(see picture) until the hood will stay in the
1.
exact position.
D. Check
1. check on a regular basis ground connection between hood
and duct with instrument or buzzer
2. When replacing hoses the ground connection must be
checked.
021213/0 MiniMan-100 ATEX
MAinTEnAncE insTrucTion
© Copyright 2008: All rights reserved. All information within this printed matter may not be reproduced,
handed over, copied, xeroxed or translated into another language in any form or means without written
permission from Plymovent AB. Plymovent AB reserves the right to make design changes.
A
friction joint
date: 04-08-04
Product no:
MMh-100-15-ATEX
MMh-100-21-ATEX
b
friction joint
MiniMan/100/En/5/8
EN - 5