Publicité
Les langues disponibles
Les langues disponibles
EN
Palm orbital sander
I
Before connecting accessories make sure the compressor is shut down.
Only use accessories and consumables that are designed for the use with this tool.
Select the best available inserted/mounted accessories/consumables for the lowest possible noise level and vibration.
Replace them in case of an increased noise level and/or vibration.
Make sure that the inserted/mounted tool/accessory is properly held by the retainer and make sure that the retainer
is in good condition. Never use the tool without a retainer as this may cause high speed projectiles.
Only use sanding pads, as worn-out pads require excessive pressure and can break.
WARNING: only use accessories suitable for working at 10500 rpm speed
Never cool down a hot tool/accessory as this may influence the hardness causing dangerous circumstances.
Use the inserted/mounted accessory/tool according the manufacturer specifications.
DO NOT operate the tool freely, It must always be in contact with the work surface. Failure to do so can cause
Retainer, Cylinder or housing failure which may result in injury to the operator and will invalidate warranty.
If a chisel is released by the retainer whilst in use, stop the tool immediately and re insert the chisel.
Before start using the tool, make sure that you are familiar with the workplace and surrounding area.
Always obey the safety regulations for the work area you are working in.
Hold the tool always firmly with both hands.
During operating the tool, the operator may be exposed to hazards as crushing, impacts, heat, vibration, cuts,
abrasions, etc: Wear suitable gloves.
Any person handling the tool must be able to handle the size, weight and power of the tool.
Always be prepared for normal/abnormal movements/forces generated by the tool.
Keep your body in balance, place your feet safe and secure.
In case of interruption of the air supply, release the lever/trigger.
When using a power tool, you may experience discomfort in your hands, arms, shoulders, neck and other parts of
your body.
If you experience symptoms such as persistent or recurring discomfort, pain, throbbing, aching, tingling, numbness,
burning sensation, or stiffness: Do not ignore these warning signs. Stop using the tool, tell your employer and
consult a qualified health professional.
F
G
H
Fig.1
ACCESSORIES
USING A PNEUMATIC TOOL
E
D
71
B
C
A
Fig.2
Publicité
