Publicité
Les langues disponibles
Les langues disponibles
EN
•
Choose and replace the engaged accessory according to the instructions in the manual, in order to prevent
unnecessary noise.
•
Use accessories that are suitable for the application and that are in compliance with the device, and connect
them properly. Check that they are being used as per instructions and that they are correctly installed.
•
Check the wear status of the tools and accessories before every use. Replace them if necessary.
•
In case of tool replacement, during maintenance operations and when finished working disconnect compressed
air connection.
•
Disconnect the tool only when the hose is NOT pressurized in order to avoid its uncontrolled motion.
•
Keep the work area neat.
•
Make sure the tool has come to a full stop before you lay it on the ground
•
Store the pneumatic tool clean and in a dry place
•
Always make sure the work station is steady.
•
Firmly hold the work piece with a clamp or a fixing tool.
•
Use the tool only for its original application. The manufacturer waives any liability for damages arising out of
the non observation of safety regulations or for tool misuse.
•
Use only accessories that are suitable for the tool in use.
•
The quality of the compressed air must be good, which means clean, dry and this is best assured by means of an
air filter. We advise the use of a complete FRL (filter, regulator, lubricator) unit. The oiler has to be adjusted to
approx. 3 to 6 droplets per minute. The air hose between oiler and tool should never exceed a length of 6 to 8
meters.
•
Pneumatic tool generate vibrations. An extended use and a wrong posture may cause damage to hands, fingers
and elbows. Immediately pause using the product as soon as you feel any pain, tingling sensations or any other
disorder. Should the problem persist, seek a physician's advice before resuming your work.
17
Publicité
