Epson C824431 Mode D'emploi page 2

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However. there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
This digital apparatus does not exceed the Class B limits for radio noise emissions
from digital apparatus as set out in the radio interference regulations of the Canadian
Department of Communications.
Le présent appareil numérique n' émet pas de bruits radioélectriques dépassant les
limites applicables aux appareils numériques de Class B prescrites dans le réglement
sur le brouillage radioélectrique édicté par le Ministére des Communications du
Canada.
The connection of a non-shielded printer interface cable to this printer will invalidate
the FCC Certification of this device and may cause interference levels which exceed
the limits established by the FCC for this equipment. If this equipment has more than
one interface connector, do not leave cables connected to unused interfaces.
Seiko Epson Corporation shall not be liable against for any damages or problems
arising from the use of any optional or consumer products other than those
designated as Original Epson Products or Epson Approved Products by Seiko Epson
Corporation.
All rights reserved. Reproduction of any part of this manual in any form whatsoever
without Seiko Epson's express written permission is forbidden.
The contents of this manual are subject to change without notice.
All efforts have been made to ensure the accuracy of this manual. However. should
any errors be detected. Seiko Epson would greatly appreciate being informed of them.
The above notwithstanding, Seiko Epson can assume no responsibility for any errors
in this manual or their consequences.
Copyright © 2006 by Seiko Epson Corporation, Nagano, Japan
FCC COMPLIANCE STATEMENT
FOR AMERICAN USERS
FOR CANADIAN USERS
WARNING
NOTICE