switel BCF 850 Mode D'emploi page 74

Operating the Monitor
Voice operated transmitter (VOX) and vibration alarm
If the equipment is operated in energy-save mode, the system starts transmitting automatically from the
camera to the monitor immediately a voice or sound is detected (VOX
the same time (vibration alarm).
If no voice or sound is detected for longer than one minute, transmission is automatically interrupted.
There is a slight delay in the transmission before the monitor can reproduce the voice/sound and
picture.
VOX transmission is activated via the menu, refer to "Menu Structure"
Motion detector and vibration alarm
If the equipment is operated in energy-save mode, the system starts transmitting automatically from the
camera to the monitor immediately the camera detects a movement in the area being observed. The mon­
itor starts to vibrate at the same time (vibration alarm).
If no further movements are detected for a certain time, transmission is ended automatically.
There is a slight delay in the transmission before the monitor can reproduce the voice/sound and
picture.
The motion detector is activated via the menu, refer to "Menu Structure"
Restarting the monitor
If the monitor no longer behaves as described, restart the monitor:
Press the Reset button using a thin, firm object, e.g. a straightened paper clip, to restart the camera.
Resetting the default settings on the monitor
You can use the menu to reset all the settings to their default state, refer to "Menu Structure" (Default),
Page 66.
Displaying the memory capacity
You can use the menu to display the memory space available:
S
in total
S
on the microSD card and
S
locally in the device
Refer to "Menu Structure", (Capacity), Page 66.
1
VOX: Voice Operated Transmission = sound detection
74
1
). The monitor starts to vibrate at
(Voice Control), Page 65.
(Motion Control), Page 65.