switel BCF 850 Mode D'emploi page 69

When switched on, the icon bar on the monitor screen indicates the battery charge status of the
camera (blue) and monitor (green).
The colors run through the segments in the battery icons in the display during charging. When the battery
is fully charged, the respective battery icon is filled fully.
When charging the battery for the first time, it should be charged for at least 4 hours without inter­
ruption. This lengthens the service life of the battery!
Stand with clip
S
Take hold of the stand on the rear side of the monitor at the bottom and pull it away from the unit a
little to position the monitor.
S
You can use the clip on the stand to attach the monitor to other objects.
Defining the language
The language is defined using the menu, refer to "Menu Structure" (Language), Page 65. There are 4
languages available for selection.
Registering the camera on the monitor (registration process)
The monitor and camera are already registered with each other at the factory.
However, up to 4 cameras can be registered on the monitor. Other cameras can be registered on the
monitor as follows:
1. Switch the monitor on.
2. Switch the (new) camera on.
3. Press the Menu/OK button on the monitor to open the menu.
4. Use the Scroll right button or Scroll left button to select the
5. Use the Scroll up button or Scroll down button to select the
6. Press the Menu/OK button to confirm your selection.
7. Use the Scroll up button or Scroll down button to select the channel to which the new camera should
be set.
8. Press the Menu/OK button to confirm your selection.
Information appears in the display on how to proceed:
9. Press the Menu/OK button to continue with the registration process. Or:
Press the On/Off / Back button to cancel the registration process.
10. Press and hold the Registration button on the camera until a message indicating successful
registration appears in the display.
If a camera is connected to the monitor, a "Y" appears behind the associated camera name in
the Register
11. Exit from the menu by pressing the On/Off / Back button, several times if necessary.
If the registration process is unsuccessful, check the battery charge status. Charge the battery,
if necessary.
menu option. If a camera is not connected to the monitor, an "N" appears.
Putting the Units into Operation
40
Setting menu option.
Register menu option.
69