Care And Cleaning; Inspection Before Reinstallation - Arjohuntleigh AtmosAir SAT Notice D'utilisation

CARE AND CLEANING

The following processes is recommended, but should be adapted to comply with local institution protocols.
If you are uncertain, you should seek advice from your local Infection Control Specialist.
The AtmosAir MRS should be routinely decontaminated between patients and at regular intervals while in use.
Do not use Phenol-based solutions or abrasive compounds or pads on the cover
during decontamination process as these will damage the surface coating.
Do not boil or autoclave the cover.
1. Remove or push bed linens to center of mattress.
The sewn AtmosAir MRS cover is cleaned by wipe down methods only.
Do not launder as damage to the base may occur.
2. Wipe and rinse any soiling from the mattress surface and base. Use 1000 ppm chlorine or 70% alcohol.
3. Dry surface with towel.
4. Ensure bed linens are refitted and not wrinkled under patient.
Inspection Before Re-Installation
Check each of the following before using the AtmosAir Stretcher Mattress with a new patient:
1. Check mattress surface for tears or cracking; do not use if tears or cracks are present.
2. Ensure mattress is free of stains and soiling; clean and / or disinfect as required.
3. Ensure ensure stretcher pan has hook-and-loop strips that match with strips on underside of AtmosAir Stretcher
Mattress (contact ArjoHuntleigh to order extra strips).
Page 4