Krups EA9000 Série Mode D'emploi page 229

Choosing the volume.
The screen displays the last volume requested. You can modify this
volume using the arrows on the left and right of the indicated value.
2
Place your cup under the coffee nozzles.
To use a large cup (or mug), you must remove the small drip tray.
Make sure that the cup fits under the coffee nozzles without
interference.
The cup must be placed close to the cleaning container.
3
Caution: use a cup that matches the volume of the recipe. The
maximum height of the cup is defined by the coffee nozzles; do not
tilt the cup to place it under the coffee nozzles.
Caution: Do not press the cleaning container (11) with the cup;
otherwise, it might break off.
Press OK. The steam nozzle then comes out of its cleaning
container to stop just above your cup.
You will need to modify the steam nozzle position using the + and -
symbols according to your convenience. If the steam nozzle is too high
from the bottom of the cup, there is a risk of splashing. Caution: The
4
nozzle must not touch the bottom of the cup either.
Press the OK button on the touch screen.
Dispensing hot water through the steam nozzle.
If necessary, the machine goes into preheating mode, then begins to
dispense hot water.
You can modify the volume of your preparation using the arrows on
the left and right of the indicated value.
Press "Stop" to stop the recipe.
5
!
Important:
The production of hot water does not stop immediately after you press the
(it takes 3 to 5 seconds to stop). Press the button sufficiently early to avoid overflows.
ENGLISH
"Stop"
button
29