Position Of The Connection Cable; Choosing The Interface Installation Position - Olimpia splendid KIT UNICO WIFI B1015 Instructions Pour L'installation, Emploi Et Entretien

2.2 Position of the connection cable

Connect the kit's communication cable to the appropriate connector on the card (Fig. 1 Ref. A) according to your
appliance model:
• Unico Inverter, Unico Air Inverter, Unico Pro Inverter ed Unico Tower, connect the cable to connector CN5
(Fig. 1 Ref. E).
• Unico Smart, Unico Air, connect the cable to connector CN1 (Fig. 1 Ref. D).
2.3 Choosing the interface installation position
2.3.1 UNICO SMART, UNICO INVERTER MODEL
The slot in which to house the B1015 card is located behind the machine on the top left.
• Disconnect air conditioner's power supply.
• Remove the machine from the wall bracket.
• Slide out the lower cover (Fig. 2 Ref. A).
• Slide out the upper cover (Fig. 2 Ref. B).
• Unscrew the 6 screws that lock the front cover (Fig. 2 Ref. C).
• Remove the front cover (Fig. 2 Ref. D).
• Remove the rear guard on the top left (Fig. 3 Ref. A) by unscrewing its two screws (Fig. 3 Ref. B).
• Place the B1015 card into the appropriate slot and then tighten its screws (Fig. 3 Ref. C) to secure it.
• Connect the communication cable to the serial port located underneath the electrical panel (Fig. 4 Ref. A).
• Route the wiring on the left side of the electrical panel (Fig. 4).
• Close the rear guard (Fig. 3 Ref. A) and tighten the screws (Fig. 3 Ref. B).
• Refit the machine's front cover (Fig. 2 Ref. D) and secure everything with the six screws (Fig. 2 Ref. C).
• Refit the upper and lower interlocking cover (Ref. 2 A and B).
• Refit the machine on the wall.
2.3.2 UNICO AIR MODEL
The slot in which to house the B1015 card is located on the machine's front panel on the top right.
• Disconnect air conditioner's power supply.
• Remove the filters above the evaporating unit (Fig. 5 Ref. A).
• Remove the 3 screws indicated in Fig. 5.
• Remove the machine from its joints by sliding it out and turning it as shown in Fig.6.
• Remove the plastic pin, if present (Fig. 7 Ref. A).
• Position the plastic spacer provided with the B1015 kit and tighten it with the relative screw (Fig. 8).
• Position the B1015 board in the housing (Fig. 7), then tighten screw (Fig. 7 Ref. B) to fasten.
• Connect the communication cable to the conditioner's serial connector (Fig. 7 Ref. D) and to the respective
connector on the B1015 card (Fig. 7 Ref. E) as specified in paragraph 2.2.
• Refit the machine's front cover (Fig. 6) and secure everything with the 3 screws (Fig. 5).
• Insert the filters above the evaporating unit (Fig. 5 Ref. A).
• Refit the machine on the wall.
22
GB