ALPHA-TOOLS A-ES 1700/1 Mode D'emploi D'origine page 19

Restart temperature (automatic): .... 30°C +/- 5°C
5. Charging the energy station
(Fig. 1)
Notice! Switch all switches to position "0".
By pressing this pushbutton (4) the LEDs (3) on
the built-in battery are lit up to show the charging
status (green=full / red=empty).
5.1 Charging the energy station with the pow-
er supply unit
1. Connect the power cable of the included po-
wer supply unit to the battery charging socket
(6).
2. Plug the power supply unit into a 230V/50Hz
socket outlet. The LED will come on.
5.2 Charging the energy station with vehicle
adapter cables
It is possible to charge the energy station with the
vehicle cigarette lighter plug.
Notice! The charging process should only take
place during a journey, as the car battery will
discharge. Never start the vehicle if the motor
vehicle adapter cable is inserted into the cigarette
lighter plug.
Insert the 12 V plug of the motor vehicle adapter
cable into the motor vehicle cigarette lighter plug
and the other end into the charging socket "(6)"
on the energy station.
6. Outputs
Caution!
Output 12 V through the cigarette lighter plug
connection.
15 Amperes max.:
•
The 12 V output (Fig. 1 / Item 12) is designed
to handle 15 A, i.e. there are max. 15 A availa-
ble to use.
•
Observe the power/electricity consumption
values of the consumer, to prevent overloa-
ding the energy station. If only the power data
of the consumer is known, the maximum
electricity value can be easily calculated.
Anl_A_ES_1700_1_SPK7.indb 19 Anl_A_ES_1700_1_SPK7.indb 19
GB
Example calculation:
Consumer: 12V / 50W
The electricity consumption is equal to:
50W / 12V = 4.17A
•
The cigarette lighter cable provided can be
used to connect a suitable consumer.
It is protected by a 10 A fuse.
•
In order to use the 12 V output, remove the
protective cap and connect the consumer.
Observe the voltage and electricity values
of the appliances to be used, in order not to
overload the energy station.
Overload could lead to destruction of the
appliance.
The ON/OFF switch (2) for the jump-start cable
must be in position "0".
7. Using the light
To switch the light on, proceed as follows:
The light (Fig. 1 Item 7) is switched ON and OFF
with the switch (Fig.1/Item 10).
8. Jump-start for motor vehicles
Danger!
•
The charging cable with pole clips are situa-
ted on the side of the appliance.
•
If you do not need the charging cable, do not
remove this from the appliance.
•
Important. Danger of short-circuit if pole clips
are contacted.
•
The energy station can only be used to
jump-start partially discharged motor vehicle
batteries. This means you can only convey a
limited capacity into the motor vehicle battery.
•
The energy station is NOT designed to
start completely discharged batteries!
The terminals are insulated to prevent accidental
short-circuiting when connecting the terminals to
the vehicle's battery and parts. Short-circuits must
be avoided at all costs.
The jump-start feature of the energy station off ers
a welcome helping hand when having start-up
diffi culties because of low battery capacity in the
motor vehicle battery.
We would like to point out that even standard
- 19 -
21.07.14 08:21 21.07.14 08:21