Haier HWF5300AW Manuel De L'utilisateur page 28

Repairs to the washing machine must only be carried out by qualified personnel. Repairs
carried out by inexperienced persons may cause injury or serious malfunctioning.
Contact your local service center.
Warning code
ErLC
ErUL
bloc punp
Err3 temperature sensor error
Err4
no taps
Err7 motor no rotation error
Err8
Er10 water level sensor error
UNB
EUAr between user interface
board and power board
door
PF
Abnormal item
door lock abnormal
door unlock abnormal
drainage abnormal
heating resistor failure
water inlet error
water over flow error
unbalance error
communication error
door not closed
The Power is Low
Solution
Pushing the door to check whether it is properly
close; cut off the power and then turn on again.
If error still exist, please contact service personnel.
Cut off the power and then turn on again. If error still
exist, please contact service personnel.
Cut off the power.
Check if the drain hose is bent or clogged.
Check if the height of the drain hose end is more
than 96" above the floor.
Check if the drain filter is clogged.
If error still exist, please contact service personnel.
Please contact service personnel.
Please contact service personnel.
Check the two water inlet hose nuts to see if they are
properly fixed.
Check if the inlet hoses are bent or clogged.
Check if the water tap is not turned on.
Check if the water supply is failed.
If the problem is solved, touch the Start/Pause pad to
continue the cycle; If error still exist, please contact
service personnel.
Please contact service personnel.
The washer will auto drain out of water, and then
auto clean up; If error still occur, please contact
service personnel.
Please contact service personnel.
It is not recommended to wash single item.
1.Cut off the power.
2. Redistribute the washing clothes.
3. Restart the spin cycle by touching "RINSE&/SPIN"
pad twice.
Please contact service personnel.
Close door, then touch the "start" pad again.
Please Contact Service Personel
English
26