Installing In The Recessed Housing; Installation And Initial Commissioning; Final Installation Step/Cleaning And Care - TCi luna Série Mode D'emploi

7. Installing in the recessed housing

The four fixing screws of the luna should be already located in the screw holes of the
device. If the screws are not there, they will be included with the accessories of the
luna. Connect the supply cable to the power supply now. The device will start after being
switched on once the voltage supply is connected (see below).
Oben / Top
The device should only be installed by authorised specialists and
!
electricians. tci GmbH cannot accept any liability for the mounted housing
and its function. Specialist personnel must inspect the device.
Install only when the supply cables are disconnected from the power.
Functions of the reset button when device
is switched on:
• Pressing resets the system and restarts
the device
Functions of the reset button when device
is switched off:
• Briefly pressing switches the device on
luna7-VI /
pureKNX-trend7
11.06.2014
Rev. 1.1
The reset button can be accessed using the tip of a ballpoint pen
or the end of a paper clip. Do not exert too much force on the
button as it could damage the device.
Ludwig-Rinn-Straße 10-14 • D- 35452 Heuchelheim/Gießen • Phone: +49 6 41-9 62 84-0 • Fax: +49 6 41-9 62 84-28 • www.tci.de
12 / 15

8. Installation and initial commissioning

1) Connect the touch panel to your network.
2) Then connect the voltage supply. The operating system will boot up automatically.
Note:
Reset
Under certain requirements, this process may take several minutes during initial commis-
sioning, as drivers must configure themselves automatically. The touch screen does not
Mini USB
respond in this state.
Mikrofon/
Microphone
Helligkeitssensor/
Brightness sensor

9. Final installation step/cleaning and care

Reset
Cleaning and care of the front frame
Only suitable cleaning agents can be used for the cleaning and care of the frame.
Ludwig-Rinn-Straße 10-14 • D- 35452 Heuchelheim/Gießen • Phone: +49 6 41-9 62 84-0 • Fax: +49 6 41-9 62 84-28 • www.tci.de
You can now remove the protective film from the front.
!
Never cover the air vents on the top and bottom of the device.
13 / 15