Environmental Concerns - Zanussi ZRX307W Notice D'utilisation

2
1
1. Remove the plug from
the power socket.
2. Remove the top hinge
cover.
3. Unscrew the 2 retaining
screws, and remove the
hinge from the appliance.
4. Take the door off.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the gas-
ket may not fit perfectly to the cabinet. In that case, wait
for the natural fitting of the gasket.
In case you do not want to carry out the above mentioned
operations, contact the nearest After Sales Service Force.
The After Sales Service specialist will carry out the rever-
sibility of the doors at your cost.
Electrical connection
Before plugging in, ensure that the voltage and frequency
shown on the rating plate correspond to your domestic
power supply.

Environmental concerns

The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
5. Remove the screw fixing
the lower door hinge and
the other screw fixing the
lower door hinge and the
foot. Then remove the door
hinge and the foot as
shown in the Figure.
6. Loosen the screw fixing
the foot opposite the lower
door hinge in order to re-
move the foot.
7. Fix the door hinge and
the corresponding foot on
the opposite side and then
the other loosened foot at
the former place of the door
hinge as shown in the Fig-
ure.
8. Please make sure to
place the lower foot below
the door hinge. The lower
foot is recognizable by its 4
ribs on the outer surface.
9. Fix the door onto the
lower hinge pin.
10. To fit top door hinge,
remove the plastic blanking
plugs carefully, and refit
them in the holes left by the
hinge retaining screws.
The appliance must be earthed. The power supply cable
plug is provided with a contact for this purpose. If the do-
mestic power supply socket is not earthed, connect the
appliance to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
disposed of correctly, you will help prevent potential
negative consequences for the environment and human
health, which could otherwise be caused by inappropriate
waste handling of this product. For more detailed
information about recycling of this product, please contact
11. Refit the top hinge us-
ing the 2 retaining screws,
taking care that the edge of
the door is parallel with
side of the cabinet.
12. Replace the hinge cov-
er.
13. Relocate the handle and
the plastic plugs to the op-
posite side.
14. Level the appliance,
wait for at least four hours
and then connect it to the
power socket.
19