Transport; Storage; Guarantee; Possible Faults - ATIKA T 250 Instructions D'utilisation

• The saw blade is a wearing part and becomes blunt after
long or frequent use
⇒ renew the saw blade or have it sharpened

Transport

Remove mains plug before each transport.
The saw must only be transported with the saw blade
lowered and the protective cover in position.
This will avoid possible injury from the saw blade.

Storage

Remove the mains plug from the socket.
Store unused equipment in a dry, locked place out of the
reach of children.
To extend the service life of the saw and guarantee smooth
operation, before storing for a longer period
− thoroughly clean the saw
− treat all movable parts with an environmentally friendly oil

Possible faults

Fault
Machine fails to start after
switching on or switches off
during idle running
Machine stops while cutting
Workpiece sticks when
feeding
Burn marks at the cut edges • Saw blade is unsuitable for the cutting
Chip exit blocked
Motor running, saw blade will
not turn.
Possible cause
• Power failure
• Extension cable defect
• Motor or switch defect
• Saw blade sticks
• Saw blade blunt
• Feed too large
• Motor protecting switch has tripped
• Saw blade blunt
• The longitudinal or parallel stop is not
parallel to the saw blade, see p. 23
task or blunt
• No exhaust suction connected
• Suction too weak
• V-belt too loose or defect

Guarantee

We grant a guarantee of two years, commencing with the day of
delivery from the dealer's store, for material and manufacturing
faults.
Warranty claims, even during the warranty period, will not be
accepted for damages due to incorrect handling or inadequate
packaging during return of the devices or to a non-observance
of the operating instructions.
Faulty parts must be sent to our works, postage or freight free.
We reserve the right to decide upon free spare part delivery.
Guarantee work will be completed by us or an authorised
servicing agency. Guarantee damage can only be remedied by
another firm with our explicit approval.
The guarantee does not cover normal wear to: saw blade,
protective hood, sliding body, table insert.
Guarantee is also granted if original spare parts are used.
Subject to changes in the interest of technical progress.
Removal
• Replace fuse
• Check cable, no longer use defect cable
• Have motor or switch checked by an approved
electrician or replaced by original spare parts
• Remove the cause of the jam.
• Replace saw blade
• Allow the motor to cool off and then continue work
using less pressure
• Switch motor back on after cooling "Motor protection",
p. 22
• Hold the workpiece firmly and switch the motor off
immediately. The have the saw blade sharpened or
renew
• Readjust the scale, see p. 23
• Replace saw blade or have it sharpened
• Switch off saw and remove chips
• See "Safe working"
• Contact an authorised customer service workshop
24