ASROCK K10N78hSLI-WiFi Mode D'emploi page 26

2.9 eSA 2.9 eSAT T T T T AII Inter 2.9 eSA AII Inter AII Inter face Introduction AII Inter
2.9 eSA 2.9 eSA AII Inter
NOTE:
1. If you set "SATA Operation Mode" option in BIOS setup to AHCI or RAID mode, Hot
Plug function is supported with eSATAII devices. Therefore, you can insert or remove
your eSATAII devices to the eSATAII ports while the system is power-on and in
working condition.
2. If you set "SATA Operation Mode" option in BIOS setup to non-RAID mode, Hot Plug
function is not supported with eSATAII devices. If you still want to use eSATAII
function in non-RAID mode, please insert or remove your eSATAII devices to the
eSATAII ports only when the system is power-off.
3. If you want to use the eSATAII HDD as an OS disk, please set "SATA Operation
Mode" option in BIOS setup to non-RAID mode. If you want to use the eSATAII HDD
as a removable data disk, please set "SATA Operation Mode" option in BIOS setup
to RAID mode. If you want to add the eSATAII HDD as a RAID disk, please set "SATA
Operation Mode" option in BIOS setup to RAID mode.
4. Please do not configure your eSATAII HDD as a RAID disk; otherwise, it may affect
the Hot Plug function that eSATAII HDD should have.
5. Please refer to page 28 to 31 for detailed information of RAID mode, non-RAID
mode and AHCI mode.
How to install eSATAII?
SATAII_6 (PORT5)
1. In order to enable the eSATAII port of the I/O shield, you need to connect the
orange SATAII connector (SATAII_6 (PORT5); see p.2/3 No.11) and the eSATAII
connector (eSATAII_TOP; see p.2/3 No.36) with a SATA data cable first.
Connect the SATA data cable
to the orange SATAII
connector
(SATAII_6 (PORT5))
2 6 2 6 2 6
2 6 2 6
ASRock K10N78hSLI-WiFi / K10N78hSLI-1394
face Introduction face Introduction face Introduction
face Introduction
Connect the SATA
data cable to the
eSATAII connector
(eSATAII_TOP)
eSATAII_TOP
Motherboard