Dometic 935000.140 Instructions D'installation Et D'utilisation page 8

INSTALLATION INSTRUCTIONS
FIG. 9
17. With the rafter pole (19) still in the side panel
(20), place the rubber tip (18) into the pole holder
(12) under the awning rail. Apply pressure on the
rafter pole toward the RV wall compressing the
spring and put the metal pin in the top hole of
the roller tube clamp (8). See FIG. 4, FIG. 7, &
FIG. 9. Repeat on the other end.
18. Make sure the height of the roller tube is adjusted
so that all panels hang straight and level. See
FIG. 10 & FIG. 11.
FIG. 10
Correct
FIG. 11
Incorrect
19
20
FIG. 12
FIG. 13
8
19. Slide three poly rope clips (21) onto the poly
rope sewn on the side panel. Position the top
poly rope clip about 4" directly below the pole
holder (12) and drill a 1/8" pilot hole (23) for the
installation of the twist fastener (24). Use a string
and plumb bob to place the remaining twist
fasteners (24) evenly spaced in a straight line
down the wall of the RV. See FIG. 12 & FIG. 13.
 T he side panel assembly comes with eight
poly rope clips (21) and twist fasteners
(24). Only three clips are required for each
side. The extra are spares and can be
used if necessary. If the side panel is over
a window or storage compartment door,
place the poly rope clips immediately
above and below.
12
24
20. Apply silicone sealant to the back and threads of
the twist fasteners before screwing them to the
side wall.
21. Slide each poly rope clip to mate up with its twist
fastener and attach it to the side wall. Repeat on
the opposite side.
23
21
Space Twist
Fasteners For
Poly Rope Clips
In A Straight
Line On The Wall
Of Coach