ASROCK X58 Deluxe Mode D'emploi page 17

1. In single VGA card mode, it is recommended to install a PCI Express

x16 graphics card on PCIE1 slot.

2. In CrossFireX

Express x16 graphics cards on PCIE1 and PCIE3 slots. Therefore,

both these two slots will work at x16 bandwidth.

3. In 3-Way SLI

cards on PCIE1, PCIE2 and PCIE3 slots. Therefore, PCIE3 slot will

work at x16 bandwidth while PCIE1 and PCIE2 slots will work at x8

bandwidth.

4. In Quad CrossFireX

graphics cards on PCIE1, PCIE2, PCIE3 and PCIE4 slots. Therefore,

all these four slots will work at x8 bandwidth.

5. Please connect a chassis fan to motherboard chassis fan connector

(CHA_FAN1 or CHA_FAN2) when using multiple graphics cards for

better thermal environment.

Installing an expansion card

Step 1.

Before installing the expansion card, please make sure that the power

supply is switched off or the power cord is unplugged. Please read the

documentation of the expansion card and make necessary hardware

settings for the card before you start the installation.

Step 2.

Remove the system unit cover (if your motherboard is already installed in a

chassis).

Step 3.

Remove the bracket facing the slot that you intend to use. Keep the screws

for later use.

Step 4.

Align the card connector with the slot and press firmly until the card is

completely seated on the slot.

Step 5.

Fasten the card to the chassis with screws.

Step 6.

Replace the system cover.

ASRock X58 Deluxe Motherboard

mode or 2-Way SLI

mode, please install PCI

mode, please install PCI Express x16 graphics

mode, please install PCI Express x16

1 7