Squeegee Installation - Nilfisk Advance SC6000 36C Mode D'emploi

SQUEEGEE INSTALLATION

1 See Figure 6. Ensure the Squeegee Seal (AA) is free from debris and installed on the Squeegee Assembly (24). Lift the squeegee
assembly by its Handles (AB) and slide it onto the Squeegee Mount (AC) and tighten the Squeegee Mount Thumb Nuts (21).
2 Connect the Recovery Hose (33) to the squeegee mount (AC).
3 Lower the squeegee and move the machine ahead slightly. Check that the rear squeegee blade touches the À oor evenly across its entire
width and is bent over slightly as shown in the squeegee cross section (AD). If necessary adjust the rear squeegee to the proper height and
angle by following the steps in the "Squeegee Adjustment" section.
FIGURE 6
AB
4/2016
INSTRUCTIONS FOR USE
21
AA
24
33
21
AC
56091161 - SC6000
ENGLISH - A
AB
AD
A - 17