About the water dispenser:
If the water flow is abnormal:
Check that:
• The tank is well installed.
• The tank gaskets are well assembled.
If dripping occurs:
Check that;
• The tap is well assembled.
• The tap gaskets are well assembled.
IMPORTANT NOTES:
• The compressor protection thermal fuse will blow after a sudden loss of power of after the
appliance is unplugged. This is beacuse the gas in the cooling system has not stabilised
and is nothing to worry about. Your fridge will start wihin 5-10 minutes.
• If you do not intend to use your fridge for a long time (e.g. in summer holidays) unplug
it and clean once defrosting has taken place (see SECTION 4). Leave the door open
to prevent humidity and smells.
• If a problem persists after you have followed all the instructions above, please
consult to the nearest Authorised Technical Service Centre.
• The appliance you have purchased is designed for domestic use and can only be used
at home and for the stated purposes. It is not suitable for commercial or common use. If
the consumer uses the appliance in a way that does not comply with this, we emphasise
that the manufacturer and the dealer will not be responsible for any repair or failure
within the guarantee period.
Tips for saving energy
1.Install the appliance in a cool, well ventilated room , but not in direct sunlight and not near
a heat source (radiator, cooker.. etc). Otherwise use an insulating plate.
2.Allow warm food and drinks to cool down outside the appliance.
3.When thawing frozen food, place it in the refrigerator compartment. The low temperature
of the frozen food will help to cool the refrigerator compartment when it is thawing. This
will help to save energy. If the frozen food is put out, it results in a waste of energy.
4.Cover drinks or other liquids when placing them in the appliance Otherwise humidity
increases in the appliance. Therefore, the working time gets longer. Also covering drinks
and other liquids helps to preserve smell and taste.
5.Try to avoid keeping the doors open for long periods or opening the doors too frequently as
warm air will enter the cabinet and cause the compressor to switch on unnecessarily often.
6.Keep the covers of the different temperature compartments (crisper, chiller ...etc ) closed
7.Door gasket must be clean and pliable. Replace gaskets if worn.
EN -25-