Cleaning The Water Tank - Gorenje NRK7191TX1 Mode D'emploi

Filling the water tank
• Remove the top cover of the water tank.
• Fill the tank up with water.
• Mount the top cover back on the water tank.
Attention
• Do not use the water dispenser for anything except water.
• If you leave water in the tank for a long time it could cause an odour. In this case, clean
the tank and keep using it.
• Clean the water tank before using it for the first time.

Cleaning the Water Tank

• Lift the water tank.
• Remove the tank cover by releasing the side locking covers.
• Clean the tank with warm water and reassemble the pieces that you have removed.
Stowing the Water Tank
• Install the water tank as shown.
• Make sure that the tap and the hole match each other while installing.
• Water flow may not be as expected if the tank has not been installed properly. Also check
that the gaskets have been assembled properly.
Drip Tray
• Use of the dispenser may cause water to collect in the drip tray. Remove the tray to
empty the water and then re-fit the tray.
Filter detail
There is a filter cover with a filter in at the back of the top
cover. Do not use this cover.
Please contact an authorised service agent about
exchanging the cover.
Please contact an authorised service centre about
opening the cover and exchanging the filter.
ATTENTION:
PLEASE HOLD THE GLASS MOMENTARILY AFTER DISTRIBUTION TO AVOID DRIPS.
Visual and text descriptions In the accessories section may vary according
to the model of your appliance.
EN -16-