Installation - for contractors
7.
Safety
Only qualified contractors approved for the work to be done may carry out installation, commissioning, maintenance and
repair of the appliance.
We guarantee trouble-free function and operational reliability only if the original accessories and spare parts intended for
the appliance are used.
7.1
Instructions, standards and regulations
The appliance is not suitable for rooms that are at risk of fire or explosion as a result of chemicals, dust, gases or vapours. In
workshops or other rooms where flue gases, oil and petrol vapours etc. are present, or solvents and chemicals are used, lasting,
unpleasant odours and possibly contamination can occur.
Please read
Only fit the appliance to a vertical wall that is temperature-resistant to at least 80 °C.
Please read
Observe the minimum clearances in the chapter "Specification".
Please read
Carry out all electrical connection and installation work in accordance with national and regional
regulations.
Please read
Observe the safety zones in the chapter "Specification". Install the appliance in such a way that control
equipment cannot be touched by a person in the bath or shower.
Please read
The appliance is delivered fully wired. The appliance must be able to be separated from the mains
power supply by an isolator that disconnects all poles with at least 3 mm contact separation. For this,
use contactors, mains isolators, fuses, etc. Installation with permanent power cables is not permitted.
Please read
Observe the type plate. The specified voltage must match the mains voltage.
8. Appliance description
8.1
Standard delivery
° Appliance
° Wall retainer
° Operating and installation instructions
9. Installation
9.1
Installation location
Observe the minimum clearances (see chapter "Specification").
»
Never install the appliance under a window sill, behind a door or under an air extract duct.
»
Never install the appliance directly below a wall socket.
»
18